Test & measurement equipment repair

We confirm before you send anything Diagnosis and quote first Rijnstraat 76-H, Amsterdam

Test equipment is only useful if it can be trusted. Repairs cover the hardware: displays, power circuits, connectors, input protection and control boards. Calibration and traceability are a separate requirement: where a calibration certificate is needed, check with us first whether it is available.

Specialist equipment: we confirm per device whether we can repair it.

Send a request

Brands we currently handle

Only brands switched on for this category are listed. A brand that is not listed may still be possible: ask before you send anything.

Anritsu
Chauvin Arnoux
Fluke
GW Instek
Hioki
Keysight Technologies
Rigol
Rohde & Schwarz
Siglent
Tektronix

Device types

Oscilloscopes
Spectrum analysers
Network analysers
Professional multimeters
Signal generators
Electronic loads
Calibration equipment
RF test equipment
Laboratory power supplies

Availability depends on the model and on parts.

Typical problems

Display faults
Power-supply and power-circuit faults
Connector and input-port damage
Input protection faults, such as a blown front end
Control-board faults
Diagnostics for calibration drift

How it works

1
Send a request

Use the form below with the brand, model and a description of the fault. Photos help.
2
We confirm

We tell you whether we can repair it, before you bring or send anything.
3
Hand it over

Bring it, send it by post or agree on-site service, whichever is available for your device.
4
Diagnosis and quote

We find the fault and send a quote. Nothing is repaired until you approve it.
5
Repair and test

After approval we repair the device and test it before it goes back to you.

Diagnosis and quotation

A quote follows the diagnosis. If a diagnostic fee applies to your device, we tell you before we start. Prices depend on the model, the fault and the parts, so no price is shown here unless it has been verified.

Handover options

We confirm the handover options for your device when you send a request.

Questions about Test & measurement equipment repair

Do you calibrate instruments after repair?

Calibration is a separate requirement. Ask us whether it is available for your instrument before sending it.

Can you repair a blown oscilloscope input?

Often this is an input-protection fault that can be assessed. We confirm for your model whether repair is practical.

How do I send a repair request?

Use the form on this page with the brand, model and a description of the fault. We reply to say whether we can repair it before you bring or send anything.

Do I pay for a diagnosis?

If a diagnostic fee applies to your device, we tell you before we start. We only begin work after you have approved the quote.

My brand or model is not listed. Can I still ask?

Yes. The list shows what is switched on today. Other brands and models are sometimes possible, so ask first.

What happens to the data on my device?

Make a backup first. We cannot guarantee that data survives a hardware repair.

Related categories

Drones & professional robotics Laboratory & scientific electronics

Send a repair request

Tell us what you have and what is wrong. We reply by email to say whether we can repair it.

Name

Phone (optional)

Brand

Model or model number

How would you like to hand it over?

What is wrong?

We use your details only to answer your request. Read our privacy policy.